project content admininistration
	list projects	new project

project
section
	edit step
id	18
sequence
text	To cut the curved slot for the cam in the upper jaw, use a 7/16 inch wide dado blade on the table saw set to a height of 7/8 inch. Place a piece of tape on the rip fence to mark where to stop the cut. Put a folded over piece of paper in the kerf to avoid cutting into the jaw on the other side of the kerf. Make the cut in the upper jaw is centered across its thickness. Slowly pull the jaw straight back out of the blade once it has been pushed to the mark on the fence.
src_1 [v]	select
src_2	select
src_3	select